Firmware Version: v1.01.25

Release Date: October 17, 2005

Summary of changes:

1. For Australia region
2. Fixed NTP sync issue with correct Day Light Savings Time
3. Added "PPP Authentication Failed" message
4. Fixed RFC1483Bridged fail to connect to Internet when set with static WAN IP
5. Fixed VPN doesn't pass traffic under PPPoA
6. Fixed IPSec Tunnel Crash after 2~4 hours
7. Fixed PPTP Pass-through
8. Added ":" for PPP password
9. Added modulation selection for DSL
10. Allowed WAN IP to be the same as Gateway IP for RFC1483 Bridged Static mode
11. Fixed DHCP server will not respond after changing the LAN IP to different subnet
12. Fixed the GUI refuses to save the WAN settings when WAN IP have a different subnet than Gateway using RFC1483Routed
13. When FQDN is used on both side of the VPN tunnel, the Gateway will now re-establish VPN session with the new WAN IP.
14. Fixed when changing the ATM QoS to VBR, the PPPoA would not establish WAN IP connection
15. Allow maximum PPPOA MTU value to 1500 under manual mode
16. Add timezone +9:30 for South Australia
17. Fixed WLAN performance issue when logging is enabled
18. Allow GUI setting changes for HTTPS remote-management